CMA Dishmachines CMA-180UC Bedienungshandbuch

MODEL L-1X & L-1X16 Installation & Operations Rev 1.16A 800-854-6417 FAX 714-895-2141 Owner’s Manual Keep with machine for refe

Operation 3.2.1. Pre-Scrapping It is essential that the operator thoroughly understand the importance of pre-scrapping the dishes before loading them

Maintenance 4. Maintenance The maintenance procedures detailed in this section are to be performed by qualified personnel. 4.1. Timer assembly The st

Maintenance 4.2. Quick service guide MODEL L-1X & L-1X16 INSTALLATION & OPERATION MANUAL Rev. 1.16A

Maintenance 4.3. Troubleshooting PROBLEM LIKELY CAUSE SOLUTION Power off at circuit breaker Reset circuit breaker Defective power switch Replace p

Maintenance PROBLEM LIKELY CAUSE SOLUTION Turn up supply water heater Low incoming water temperature (below 140° F) Insulate supply water pipe Thermo

Maintenance PROBLEM LIKELY CAUSE SOLUTION Defective rinse pump motor Replace pump motor P/N: 00416.00Rinse pump does not run Defective timer assembl

Addendum 5. Addendum for Machines Installed in the City of Chicago “All food dispensing establishments using chlorine or other approved chemical sani

Appendix A: Operator & Cleaning Instructions MODEL L-1X

6. Electrical Diagram (Effective 06/2007) MODEL L-1X & L-

TABLE OF CONTENTS MODEL CMA-L-1X & L-1X16 1. SPECIFICATIONS...

1. Specifications METRIC EQUIVALENT 1.1. L-1X & L-1X16 WATER CONSUMPTION PER RACK 1.7 GAL. 6.44 L PER HOUR 40.8 GAL. 154.4 L OPERATING CY

1.2. L-1X and L-1X16 Operational Cycle The L-1X and L-1X16 Operational Cycle has a total cycle time of 2 minutes (120 seconds). The Timing Diagram

2. Cam switch 7 controls the pump motor. The pump motor comes ON at the beginning of the operational cycle and continues to run until the end of th

Getting Started 2. Getting Started All sections of the manual address both the L-1X and the L-1X16. Separate information on each machine is only pr

Getting Started 2.2. Receiving and Installation The dishwasher is shipped from the factory in a corrugated box on a wooden pallet. The installatio

Getting Started A 1” male NPT fitting is provided for the drain connection on the discharge port of the diverter valve (lower, right-hand corner of

Operation 3. Operation 3.1. Initial Setup 3.1.1. Check…  Drain screen is in place  Spay arms and end plugs are secure 3.1.2. Chemicals • Assure