CMA Dishmachines CMA-180 Spezifikationen

MODEL CMA-180 Installation & Operation Rev 2.03 800-854-6417 FAX 714-895-2141CMA DISHMACHINES 12700 KNOTT AVENUE GARDEN GROVE, CALIFO

2.2.5. Water Tempering Kit MODEL CMA-180 INSTALLATION & OPERATION Rev. 2.03 Page 9

2.2.6. Installation Checklist  Dishmachine checked for concealed damage.  Hot water supply is 140° (60°C)  Incoming water supply line is ¾”.

2.2.7. Machine Start-Up Procedures 1. Open doors and install the overflow & scrap trap on the right side of the machine. 2. Place the scrap b

2.2.8. Electrical Requirements The CMA-180 comes standard factory, wired for 3-phase operation. Check the electrical data plate to confirm this. I

3. Wiring Options 3-Phase and 1 Phase Wiring Options Single-Source 220V 3-Phase (20 amp/12 g*) Single-Source 220V 3-Phase (50 amp/8 g*) Sing

4. Quick service guide MODEL: CMA 180 HIGH TEMP TECHNICAL ISSUE CAUSE SOLUTION Door magnetic reed switch problem Faulty magnetic reed switch Chec

5. INITIAL PARTS KIT P/N 1100.17 P/N DESCRIPTION NO. REQ’D 00121.18 CMA-180 Drain Stopper O Ring 1 00200.10 Pump Assy 110/220V 60 Hz (Open

6. Auto-Fill Solid State Timer 1236 AUTO-FILLSWITCHWATERSOLENOIDVALVEWASH PUMPCONTACTORT1T2L1L2 Pre-selected delay period can be adjusted by turn

7. Wire Diagram MODEL CMA-180 INSTALLATION & OPERATION Rev. 2.03 Page 17

8. Wire Diagram for CMA-180 Booster Only WASH PUMPCONTACTORT1T2L1L2GROUNDPUMPMOTORWASH TANKHEATERHEATERCONTACTORT1T2T3L1L2L35kWBOOSTERHEATERCONTACTO

Table of Contents CMA-180 1. SPECIFICATIONS... 2 1.1

1. Specifications 1.1 CMA-180/CMA-180T Metric Equivalent WATER CONSUMPTION PER RACK .96 GAL. (3.6 L) PER HOUR 52 GAL. (197 L) OPERATING CYCLE

1.1. CMA-180/CMA-180T ELECTRICAL RATING VOLTS PHASE AMPS WITHOUT BOOSTER 208 1 28/35 240 1 30/38 208 3 20/24 240 208 240 208 ELECTRICAL RA

2. Getting Started 2.1. Introduction to CMA-180 The CMA-180 is a hot water sanitizing, single rack, door-type dishmachine. It is a stand-alone mac

2.2. Receiving and Installation Step 1: Remove packaging material. Step 2: Remove service manual and machine legs from inside the wash tank. Step

flexibility to permit the machine to be moved for cleaning without having to disconnect any wiring. ii. Run your dispenser wires through the conduit

2. Remove the plug from the mixing chamber located by the vacuum breaker on the back of machine; and install the rinse injection fitting (supplied

2.2.4. Exhaust Fan Control MODEL CMA-180 INSTALLATION & OPERATION Rev. 2.03 Page 8